![]() ![]() Are doors and drawers inset, overlay or half inset?ĭrawer faces were sometimes half inset even though the doors in the same set of cabinets were fully inset.When we recreated the pantry in Lauri Hafvenstein’s 1917 house, I followed the original pattern Lauri had seen in a neighbor’s kitchen, with inset doors and half-inset drawer faces. They were not usually located in the upper or lower corner, as is typical of cabinet doors today. Note the position of drawer pulls, doorknobs or latches door hardware was commonly installed approximately halfway or two-thirds to three-quarters of the way up on base cabinet doors and similarly spaced in the opposite direction for upper doors. Note the distance of the top and bottom (and center, if applicable) hinges from the ends of the door. What kind of hinges were used, and how were they attached? If the doors were hung on butt hinges, were they mortised into the door and face frame, or only into the door? What is the length of the hinge? How wide are the leaves? Are the pins removable or fixed, and do they have finials? What is the finish? The pulls in the center are Bakelite with chrome from Vintage Hardware in Port Townsend, Wash. The process was more nerve-racking than it might have been because she did this routing after painting the cabinets. The core box bit removed the remainder of the waste. Before using the router, she bored out the center on the drill press to give the bit a place to plunge into. She made the concave handle detail with a router with a shop-made jig, using a rub collar and core box bit. The pulls on these metal cabinets found in a garage inspired those Lynette Breton made for her mid-century style kitchen. Even if you plan to mount your drawers on full-extension slides, you should incorporate rails between them to evoke the look of those that once supported web frames. Dimensions of face frame stiles and rails (in addition to where they appear)įor example, a true period look for cabinets predating the widespread use of mechanical drawer slides requires intermediate drawer rails. ![]() Sometimes stiles are the same width as the top rail (before material is removed for fitting the doors), sometimes not – and sometimes they are dramatically different. Hiller’s historical perspective on design might just change your mind about what makes a good kitchen.īottom rails are almost always wider than top rails on old cabinet and furniture doors. Plus butt-saving advice that comes only from experience – like how to maximize space in inside corners, how to scribe cabinets and countertops into odd spaces and how to make sure you’ve left ample space for hardware.Īll of this is built on a foundation of research into kitchens from the past. They range from the sculptural (kitchens by Johnny Grey and Wharton Esherick) to kitchens of a more recognizable form.īut there’s also a heavy dose of practical instruction: how to build cabinets efficiently, how to make a basic kitchen island, how to build a wall-hung plate rack. Yes, there are hundreds of pretty full-color photos of well-designed kitchens, which are organized into 24 case studies throughout the book. And she shows you how it can be done without spending a fortune or adding significantly to your local landfill. Unlike most kitchen design books, “Kitchen Think” is a woodworker’s guide to designing and furnishing the kitchen, from a down-to-the-studs renovation to refacing existing cabinets. The following is excerpted from “ Kitchen Think: A guide to design and construction, from refurbishing to renovation,” by Nancy R. Contrast its extreme width with the single-board thickness of the rails between the drawers. While the board between the doors does not exactly qualify as a face frame stile, that is one of its functions. This Shaker classic is one of the best examples of how frame components can influence the character of a cabinet. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |